March 2017

Fly Of the Month The Red Buzzer (Roy Coulson)

Special thanks to Roy Coulson for this month’s fly tying demonstration, the Red Buzzer. Roy started fishing in the UK, where he captained the Derbyshire Team.

He fished in the All England competition and finished 29th out of 700. 

Roy has been fly tying for over forty years and was also a tutor. He came from Taupo to demonstrate this fly, and prepared very good notes, including a pre-tied sample for all who came to the demonstration. Roy uses the red buzzer as a very effective fish catching pattern in lakes like Otamangakau and Aniwhenua. He usually fishes the Red Buzzer as the dropper, a damsel nymph on point and a dry fly as indicator. He says it is best fished static, or with a gentle lift and drop action….in many cases wave action will do the trick.

Hook:           Kamasan B110 Grubber, size 10 – 16

Thread:         Red Glo-brite Fluorescent floss (Shade No. 3)

RedBuzzerFly

Red Buzzer

Rib:           .007” copper wire

Wing Bud:    Mylar Holographic tinsel (red)

Wingcase:   Mylar tinsel (Pearl)

Method

  1. Tie on the red floss then double the floss over and tie it under the bed of floss from the eye to just around the bend of the hook. This leaves a loop which will eventually become the tail.
  2. Tie in the copper wire from the wing bud position (about 1/3 of the hook from the eye) to the tail, winding the red floss over it.
  3. Wind the red floss up to the wing bud position. Try to make 9-10 winds as this will indicate the correct number of segments.
  4. Wind copper wire to the wing bud position giving a segmented look, tie off and trim.
  5. Tie in the red Mylar wing buds keeping them evenly positioned each side of the fly.
  6. Tie in the pearl Mylar wing case on the top of the fly
  7. Build up the thorax area with tying thread.
  8. Pull both wing buds and the wing case to the tie-off point behind the eye and whip finish.
  9. Cut the loop in the tail to a realistic length.
  10. Apply resin and cure with a UV light.

                 Roy says this is a simple tie, but I found it quite tricky getting the Mylar tinsel in the correct place and tied down neatly……I obviously need more practise!

 

Bookmark the permalink.

Comments are closed